Specific requirements for punching and performance improvement of high precision mirror shaft rods

The processing of high-precision mirror shaft rods can be referred to as high-precision mirror shaft rod processing. And it is the key word of the website, so below, this work will be carried out, so that everyone can come and learn and understand, and at the same time, increase their professional knowledge in this area, so as not to stop straight in place. before. 

1. Different high-precision mirror shaft rods, is it processed in the processing technology?

High-precision mirrored shaft rods are also of different kinds, but in the specific aspect of high-precision mirror shaft rod processing, there is not much difference, in general, it is like. Therefore, the more lenient answer to this question is what it is. However, if it is strictly speaking, its answer is that these two are not the same, and there is a certain difference.

2. How to punch holes in high precision mirror shaft rods?

High-precision mirror shaft rod punching, which is also a category of high-precision mirror shaft rod processing. If you want to punch holes in high-precision mirror shaft rods, then there are several ways to do it. The trick is to perform vertical drilling. It should be noted that the shaft should be clamped and the drill process should be with high precision mirrors. The shaft line remains chic. Second, if the hole is not large, the hole can be drilled by electric drill. However, regardless of the type, it should be noted that the holes cannot be skewed.

3. In the processing of high-precision mirror shaft rods, what kind of performance needs to be improved while improving the surface finish of high-precision mirror shaft rods?

In the processing of high-precision mirror shaft rods, while improving the surface finish of high-precision mirror shaft rods, it is also necessary to improve the hardness of high-precision mirror shaft rods, as well as their wear resistance and corrosion resistance, so that high-precision mirror shaft rods can pass. After processing, it has good surface properties and performance, so as to obtain good results.

4. At the output end of the high-precision mirror shaft rod, if there is a keyway, how should I bring one sprocket?

This is a high-precision mirror shaft rod, so it must be known and understood. If the high-precision mirror shaft rod has a keyway at the output end and you want to carry a sprocket on it, if the requirement is not high, you can drill a chrome threaded hole and then lock a bolt.